DataTale AIR Manuel d'instructions télécharger pdf (Page 10)

INSERTING HARD DRIVES IN THE RAID UNIT

To assemble the RAID Unit, please follow the steps listed in the instructions below:

1. Place the RAID Unit with its Bottom View facing you. Unfasten all four (4) Casing

Screws with a Phillips screwdriver. Afterwards, turn the RAID Unit to its Cover side.

2. Lift the Cover upward to remove it. When opened, the PCBA boards (Printed Circuit

Board) should be securely in place inside the RAID Unit.

HDD Placement Holders

HDD Screws

Disk1

Disk2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

DataTale AIR Manuel d'instructions Page 10