DataTale AIR Manuel d'instructions télécharger pdf (Page 24)

REBUILD

If one of the HDDs fails, the Disk LED will become red, and the rebuild function can be

set up under RAID 1 mode. To setup Rebuild under RAID 1 mode, please complete the

following steps:

The use of identical HDDs from the same manufacturer, with the same capacity

and RPM is highly recommended.

1. When the failed HDD is removed, a popup window stating “Attention! Hot Swap”

will appear. Click on “Ok” icon to continue.

2. Another popup window will appear stating, “Attention! RAID 1 Degrade Mode”.

Click on “Ok” to continue.

When one of the HDD has failed, the Disk LED will become red. However, no

warnings will appear on RAID MASTER to notify the user. Please pay attention to the

Disk LEDs at all times.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Pas de commentaire

DataTale AIR Manuel d'instructions Page 24